Shoe Press

Shoe press is located in the PM press part. It belongs to the group of presses with an extended pressing zone. The load is controlled from 0 kN/m to the maximum load up to 1,200 kN/m.

Design

The press roll has a bending compensation through a hydraulic system or a classic press roll with crowning. The shoe press is equipped with a stationary beam on which a set of hydraulic cylinders is attached. These cylinders press down the “shoe” to the rotating flexible blanket.

The shoe profile is influenced by the shape of the loading roll. A rotating elastic blanket of the lower roll slides over a thin oil layer. Because of the hydraulic cylinders set and hydraulic unit design, it is possible to control the cross profile of the paper. It is used as a final press that is able to reach 35 – 40 % dryness when the dryness at the entrance is about 48 – 52 %.

Main parts
  • Bearing structure (1)
  • Press roll (2)
  • Shoe press roll (3)
  • Hydraulic system for the top press roll
  • Hydraulic system for the bottom press roll
  • Safety guards
Accessories
  • Drive
  • Control system and control panel
  • Assembly tools and tools for the regular exchange of the elastic blanket
  • Central lubrication and hydraulic aggregate
Advantages
  • Dryness amount after press part: improvement from 48 to 52 %
  • Reduction of steam consumption per produced tonne
  • Increased performance of machine with limited drying capacity
  • New machines with shorter drying part
  • Increased paper wet strength
  • Reduced number of web breaks
  • Enhanced effectiveness and runnability
  • Web strength parameters improvement
  • Category

    Paper Machine
  • Section

    IndustrialPaper/CulturalPaper/SpecialtyPaper




Company Presentation

[elementor-template id="3268"]
#UseMorePaper™